R1 and R2 are not forwarding the routes received from a remote PE to their customers.
Referring to the exhibit, which parameter must be added to the configuration to allow the routes to be forwarded?
multipath multiple-as
family inet-vpn
multihop
as-override
Correct answer: B
Question 2
You are asked to configure PIM-SM in your network. Your implementation must allow for load sharing between redundant RPs and, should an RP failure occur, the RP failover time should be minimized.
Which two configuration tasks are required in this scenario? (Choose two.)
Configure MSDP peering sessions between the routers designated as RPs.
Configure the shared anycast address on the RPs as the primary address on the loopback interface.
On the routers designated as RPs, configure the shared anycast address on the loopback interface.
Configure at least two static RPs and bundle them in an RP redundancy group under [edit protocols pim].
Correct answer: BD
Question 3
In a carrier-of-carrier VPN model, which type of network layer reachability information is used for the MP-BGP signaling between CE and PE routers?
flow
labeled-unicast
unicast
inet-vpn
Correct answer: D
Explanation:
In a Carrier-of-Carrier VPN environment, specify the inet-vpn address family and unicast traffic type to enable BGP to carry IPv4 network layer reachability information (NLRI) for VPN routes. References: http://www.juniper.net/documentation/en_US/junos15.1/topics/example/mpls-vpn-option2-configuration.html
In a Carrier-of-Carrier VPN environment, specify the inet-vpn address family and unicast traffic type to enable BGP to carry IPv4 network layer reachability information (NLRI) for VPN routes.