Download Cisco.352-001.TestKing.2019-07-02.96q.tqb

Vendor:	Cisco
Exam Code:	352-001
Exam Name:	Cisco Certified Design Expert Qualification Exam
Date:	Jul 02, 2019
File Size:	3 MB

Download Exam

Demo Questions

Refer to the exhibit. As the new network designer for a manufacturing company, you are designing this resilient Ethernet ring for the plant Ethernet network that is connected to the core, which does not use STP. Both edge ports are on the same switch in a ring segment. There is connectivity between the edge ports throughout the segment, so you create a redundant connection between any two switches in the ring. Which four options are characteristics of this design? (Choose four.)

If a link fails, then the alternate ports quickly unblock. When the failed ink comes back up, a physically blocked port per VLAN is selected with minimal disruption to the network.
If a link fails, then the alternate portsquickly unblock. Whenthe failed ink comes back up, a logically blocked port per VLAN is selected with minimal disruption to the network.
If VLAN load balancing is configured, then two ports in the segment control the blocked state of VLANs.
If VLAN load balancing is configured, then one port in the segment controls the blocked state of VLANs.
If all ports in the segment are operational, then one port is in the blocked state for each VLAN.
If one or more ports in a segment are not operational, thereby causing a linkfailure, then all ports forward traffic on all VLANs to ensure connectivity.
If all ports in the segment are operational, then two ports are in the blocked state for each VLAN.

Correct answer: BCEF

Explanation:

REP segments have thefollowing characteristics:If all ports in a segment are operational, one port (referred to as the alternate port) is in the blocked state for each VLAN. If VLAN load balancing is configured, two ports in the segment control the blocked state of VLANs. If one or more ports in a segment is not operational, and cause a link failure, all ports forward traffic on all VLANs to ensure connectivity. In case of a link failure, alternate ports are unblocked as quickly as possible. When the failed link is up, a logically blocked portper VLAN is selected with minimal disruption to the network.

REP segments have thefollowing characteristics:

If all ports in a segment are operational, one port (referred to as the alternate port) is in the blocked state for each VLAN. If VLAN load balancing is configured, two ports in the segment control the blocked state of VLANs.
If one or more ports in a segment is not operational, and cause a link failure, all ports forward traffic on all VLANs to ensure connectivity.
In case of a link failure, alternate ports are unblocked as quickly as possible. When the failed link is up, a logically blocked portper VLAN is selected with minimal disruption to the network.

Refer to the exhibit.

A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)

Enable Y.1731 Connectivity Fault Management on the SP switches.
E-LMI PDUs must be forwarded over VPLS.
Cisco Discovery Protocol PDUs must be forwarded over the VPLS.
Use upward maintenance endpoints on the SP switches.
Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.

Correct answer: DE

Company ABC is using an Ethernet virtual circuit as it’s provider’s DCI solution. A goal is to reduce the time to detect the link failure. Which protocol accomplishes this goal?