A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)
Configure the NVE interfaces to be Up on both switches.
Set a different distributed gateway virtual MAC address.
Set a different secondary IP addresses on NVE source-interface.
Configure the same VNI to multicast group maping.
Set a different primary IP addresses on NVE source-interface.
Correct answer: AD
Question 2
A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?
Use route-map to advertise this MAC statically and redistribute with ISIS.
Unknown unicast flooding is not allowed.
Use the otv flood mac <> command to selectively flood traffic for a given MAC.
Use the otv isis bfd <> command to configure BFD protocol.
Correct answer: B
Question 3
Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A? (Choose two.)
Configure the local vPC role priority to have a lower value than Switch-A.
Configure the local vPC role priority to have a higher value than Switch-A.
Disable and then re-enable the vPC peer-keepalive link.
Configure the local vPC role priority to have the same value as Switch-A.