The administrator configured route advertisement to a remote low resources router to use only the default route to reach any network but failed.
Which action resolves this issue?
Change the direction of the distribute-list command from out to in.
Remove the line with the sequence number 10 from the prefix list.
Remove the prefix keyword from the distribute-list command.
Remove the line with the sequence number 5 from the prefix list.
Correct answer: D
Question 2
Refer to the exhibits. An engineer filtered messages based on severity to minimize log messages.
After applying the filter, the engineer noticed that it filtered required messages as well. Which action must the engineer take to resolve the issue?
Configure syslog level 2
Configure syslog level 3
Configure syslog level 4
Configure syslog level 5
Correct answer: D
Question 3
Refer to the exhibit.
The engineer configured and connected Router2 to Router1. The link came up but could not establish a Telnet connection to Router1 IPv6 address of 2001:DB8::1. Which configuration allows Router2 to establish a Telnet connection to Router1?
IPv6 address on GigabitEthernet0/0
permit ICMPv6 on access list INGRESS for Router2 to obtain IPv6 address
ipv6 unicast-routing
permit ip any any on access list EGRESS2 on Router1